wall plug

英 [ˈwɔːl plʌɡ]

美 [ˈwɔːl plʌɡ]

墙上插座

英英释义

noun

• receptacle providing a place in a wiring system where current can be taken to run electrical devices
  Synonym:wall socketelectric outletelectrical outletoutletelectric receptacle

双语例句

• Water plug was introduced and TTAB on the capillary inner wall could be dissolved into the water plug, which enhanced negative zeta potential of the capillary section.
  再以高差法引入水塞，吸附于毛细管壁的TTAB溶解到水中，使该段毛细管的zeta电势变负；
• The results show: at lower pressure ratio, heat transfer condition on the plug surface is the worst, peak values of pressure and temperature appear along the wall of plug nozzle, temperature and temperature gradient along the section of wall reach the highest.
  计算结果表明塞式喷管发动机在较低压比的工况下工作时，塞锥受热状况较为恶劣，塞锥壁面出现压强和温度的峰值，该截面内部的温度和温度梯度达到最大。
• The wire snapped at the wall plug and the light fused
  墙上插座的电线短路烧断了保险丝，电灯跟着灭了。
• Linear deformation zone of generating wall can be obtained by means of non-linear cone angle plug combined with the barrel-shaped rolls, so the wall accuracy can be increased greatly.
  采用带有非线性顶头锥角的顶头与桶形辊相配合可以获得线性的成壁变形区，从而大大提高壁厚精度。
• Wall shear stress method integrates the plug flow displacing, the low speed displacing and the turbulent flow displacing methods in theory.
  壁面剪应力设计方法，从理论上把塞流顶替、低速顶替及紊流顶替技术统一起来。
• The process schedule to improve non-uniform shell wall thickness on plug mill is investigated.
  研究了在自动轧管机上减小荒管壁厚不均的工艺方案。
• A larger diameter with a relative thinner wall for an open-ended pile leads to a higher plug length.
  分析认为开口管桩直径越大管壁越薄，形成的土塞高度则越大。
• Presented in the paper is a summary concerning the operational practice in manufacturing of extra-heavy wall seamless steel tubes with Φ 100mm plug pipe mill.
  总结了在Φ100mm自动轧管机组上生产特厚壁无缝钢管的经验。
• The pressure distributions on the wall surface of the plug nozzle models with two different truncated length were measured under different nozzle pressure ratios and the schlieren photos of typical cases were taken.
  实验模型采用直排的点膨胀构型，实验测量了两种塞体长度的塞式喷管在不同压比条件下的表面压强分布，拍摄了典型工况下流场的纹影照片。
• Analysis on Tube Wall Thickness Accuracy Improvement Resulting from Modified Second-Piercing Mill of Φ 400mm Plug Pipe Plant
  Φ400mm机组二次穿孔机改造后钢管壁厚精度分析